SOLD, Both Sets CMI Stainless Tailpipes.

I'm not sure exactly what application these were originally intended for. I used them (one set, for less than 10 hours) in a scarab with a bravo. The cooling water mixing right at the ends of these AKA dry pipes. I ended up with 2 sets of them. One set was used for a few hours and one set has never been used. They've been kicking the garage for years and it's time for them to depart.

$250 per set + shipping. SOLD, Both Sets

PM or email [email protected]

bump

Sent you a PM. Rope seal?

if these fit your application they are a steal at this price!!!!

Were they near stadard bravo holes? Sport tubes or the 15.5" runner style?
Thanks
Steve

my application wasn't even close to standard. Originally an alpha boat that used stock manifold with big ass spacers on top of them with tips that were super high on the transom.

I converted to bravo, installed 600hp engine and ran these with with a pair of stellings with very high collectors. I had a set of flanges machined that matched the flanges on the tails and then had the flanges welded to the stellings. Amazingly it fit really well without spending 10K getting a fully custom exhaust made.

Great price, I am trying to get confirmation on the seals. My headers use the rope seals, not sure on yours. they changed to a different seal some years back. Can you show a slight angle side view of the seal flange so I can compare it to the silent choice flange I have now? That would help. Also, about 3" of header pipe slide into the flange on mine. These do the same? Sorry for all the questions, but I have too many parts lying around now that I can't use. Thanks again! Bill

more pics

this is what they were attached to

SOLD!!!!!

Both sets.