|
x2 - for an offer to sell you my TRS tie bar. Will make you a killer deal, as I have no use for it anymore.
PM or email tbarta26 "at" hotmail.com email sent! |
Originally Posted by commandersander
(Post 3036763)
And by the way.....
Wing plates on a TRS are waaaay more than a simple plate... I have them on mine. It goes over the top (4 bolts and spacers) and down the face (another 4) and the pin for the clevis is a specialty item....not readily available from the hdwr. store.... http://www.cpperformance.com/images/137-9277.jpg http://www.cpperformance.com/detail.aspx?ID=10295 |
Ends
Originally Posted by Rookie
(Post 3036730)
May I ask where you bought the tie bar ends at?
|
I've been looking for a pair of #3 SSM wingplates. They seem very expensive for a pretty simple setup. There is a local machine shop I have used before. How long should it take them to cut the pieces if I provide a very exact drawing?
|
Thank you everyone, I have found the parts I need.
|
I have a complete set up, plates ,rams, and tie bar
|
| All times are GMT -5. The time now is 11:21 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.