1BIGJIM

iTrader: (1)

Dart Pro 1 Aluminum Heads (bare)

I have 2 sets of Bare Dart Pro 1Aluminum Heads. 310/119cc rectangle ports. The valves are setup for 2.25 and 1.88.
I purchased them in December and ran into problems with my build so I purchased New Engines yesterday. I opened one box to take pictures of them. It almost made me cry, they are so light and good looking.

$1,425 a pair plus the ride.

Send me a PM or email [email protected]

1BIGJIM

iTrader: (1)

One more.

bobsbillets

You do realize you can get them from cobra power for $1250 a set new right?

1BIGJIM

iTrader: (1)

I must of got hosed.

Summit and Compitition Products have them for...

Here is the link to summit for these heads. $1,260 each.
http://www.summitracing.com/parts/DRT-19100111/

Comp Productions $937 each.
http://www.competitionproducts.com/D...info/19100010/

baja27

IBIGJIM I'll take them off your hands for $1,175.00 a set

1BIGJIM

iTrader: (1)

I will keep them for future projects before I
give them away

picklenjim

That price of the one at Summit is assembled. Their $937 for a bare one there also. Cobra's price was $1385 as being a new product for Feburary. I don't know how they could sell them that cheap. Maybe their seconds. I remember a post on here where a guy bought a set of those and one of the bolt holes was drilled off.

1BIGJIM

iTrader: (1)

I am not going to get into it on what someone else thinks they are worth. I have been building engines long enough to know what the good stuff costs.

Dart Website $976 each.
http://www.dartheads.com/products/cy...ro1-heads.html

I spoke with a Large Dart Dealer her on OSO personally and I am close to there cost.

I thought they would be gone by now.

getrdunn

iTrader: (7)

Jim
It has to make you sick to off these heads. I can only imagine whats going through your mind. I'm with you. Just hang on to them unless you get close to what you want. Otherwise put on the shelf and drink a few beers and look at them. They are awesome heads. I'm glad you at least decided what direction to go in. I know there are some good deals on castings out there however if the holes don't line up etc. it simply isn't worth it. I for one know that. I wound up purchasing 4 heads and got two different castings, one head the bolt holes didn't line up and three of them the valve cover holes were off about 3/16. By the time it was all said and done I would have been much further ahead by paying a few hundred more a set. Just my 2 cents.

Take care and good luck.

John

Velocity Vector

iTrader: (4)

Hang in there aluminum is going up Low/High 0.9250 - 0.9386