I am selling my 32' AT and removed some parts to sell seperately....

Stellings, "GREEN" full length tubular headers, BB Chevy, USED, 4.5"o.d., straight tailpipes set up for Bravo, FRESH water only, $4900 for both sets buyer assumes shipping freight

By the way, the engines are FOR SALE too...565cid. I am going to create another thread for them...

4.5" o.d. dry tails...

How old are the headers ? Have they been pressure tested ? [email protected]. Thank you. Chris

1994, The engines are out of the boat and I will be taking the headers off them this week and I will have the headers pressure tested then.

Sale pending...will advize

Okay gang, the person who was intending to buy my headers has declined because the headers will not fit his set-up. So, the sale of my headers has resumed. Buyer assumes shipping freight.

The headers have been pressure tested for leaks---there are NO leaks!

I am going to post a photo showing the heigth of the headers in inches. I also plan on having them polished.

Here's a couple photos showing the heigth....I measured them 2 different ways...from the middle of the primary port to the center of the collector it is about 12.5" to 12-3/4" tall.........OR if you measure from the bottom of the flange to the very top of the header/collector it is about 16.5 inches or so...

Still for sale

still for sale

do you know how wide thay are out side to out side on the engine .are yours tall deck blocks or short