Hi yall....

I am reassembling my drives, but I am curious as to a few specs....

How much tension should there be on the shaft when everything is reassembled?

Where can I buy more shims?

Call the shim master. I think he goes by the name Ted Tequimpski. He's right around da corner der somewhere. Good luck with your finds. Oh umm ah by the way as far as the specs go just put your index finger and thumb around the shaft. If you can rotate it without farting you should be cool in the gang. What's up dawg?

I need something sharp......

And pointy......

I have the sudden urge to poke my eyes out.....

Hey Rich,
Put a thread under the drives/trans section. There are a lot of sharp guys there on the subject. Take care my friend. Don't poke your eyes out just yet. You get the thumper sticks in yet?

No....still collecting parts.....

I did just finish painting the drives though......sweet....I'll email a pic or two....

please do. i need to do mine also. did you put new decals on? if so where did you purchase them?
john

Decals?
R

U

K
I
D
D
I
N
G

M
E
?

Think "clean".......no stikerz for this clown......

However, I did have skullz machined into the little plates that go where the stikerz USED to be......when a F A G owned it before me!!!!

That's cool you machined skulls on the plates. They match your tatoos?