Anyone interested in CMI dry tails-gasket clamp seal? I have two sets that I don't think I am going to use. Would like to sell both sets at once. They appear to be for a Bravo set up however could be used with TRS also but only with hyd. steering. All they need is a little polishing.

700.00 both sets
Plus shipping

I'm interested. Can you email pics?

[email protected]

pic

I can email some additional pics tomorrow. I would like to polish them before doing so though.
Thanks,
John

I really don't care about the polish job if they will work for me. Send me some pics and info and I'll talk to my builder.

OK,
Just let him know they are dry all the way to the point where you see them reduce down. Engine builders love these because it really opens the door for a wide variety of cams especially with tighter LSA. From CMI these would cost a fortune.

John,
Not sure what you mean by clamp seal? Rope or flat gasket seals? If rope, I'll take them but I think I'm third in line at least. Bill

Is this what we were talking about?

I know....you are still waiting on the pic and measurement....

Blah, blah....

Gasket seal. I'll get you a close up pic of the inners tomorrow. Bill will a rope seal tail fit up a gasket seal header? These are slightly cone shaped for about an 1" beyond where the clamp is.

Try and get me your pics asap.