Bunch of good Merc. parts
 

For sale.
Please check make sure what ever you want will work for you.
I don’t mind giving a refund, but I won’t pay for back and forth shipping, so check you application.
E-mail for pics.

1) High pressure fuel pump from 496 HO Mag. Use but like new condition. Wrong diagnostics. (jets needed to be cleaned, fuel pumps are fine) $100
2) Low pressure fuel pump. fuel pump from 496 HO Mag. Use but like new condition. $100
3) New High pressure fuel pump with cooler in original box, on opened. $200
4) Complete Bravo SR gears and misc. Some small items may be missing from the set. (upper driveshaft had some ware, gears etc are good) $500 for the whole thing.
5) One upper driveshaft from Bravo XR. $100 (the other shows ware so I replaced both)
6) LH, RH 30” Bravo labbed props. Test time only. $950
7) Alum exhaust elbows. (about ½ hour use) from 454 Mag. $150
8) One SBC exhaust riser. $50
9) Bunch of fittings. Most are for IMCO power steering lines and some for misc. connections. Let me know what you want. $5 to $15 each.
10) Holley carbs. Used. Planned to change from my Webbers but I would have to redo the injectors, so I just kept the old carbs. Not sure what CFM’s are these so check the numbers. $150 ea.
11) Used, but good power steering pump from 525. (Wrong diagnostic again, I had a leak in the cooler) Pump is like new. $250
12) SBC oil pump, one is used about 1-2 hours. $100. The other is new, never installed; $150
13) Speedo pick ups. 2 used, $25 one new. $50
14) Gill Stainless risers. 4 ea. $250 per set. (from Merc. 350 Mag. SBC
15) 4 Gill headers. Two in good cond. $250 per set. Two has some exterior corrosion. Fixed it but I can’t promise anything but after 40 pounds of pressure, no leaks. $100
16) Alpha one water pump housing, (lower) with all the gaskets. $15
17) SBC oil pan gaskets, and misc. left over gaskets I had duplicates. $ ?
18) SBC head gasket set. $20
19) Strainer (or ?) brass fittings. 1” to 1” and 1 ¼” to 1 ¼” () $20ea.
20) Bravo XR inner transom plate. $100 +-)

can you send pics [email protected] of exhaust

Pics sent.

I would like pics of the power steering pump and any PS parts/fittings. My email is [email protected]

Thanks
Jim

on it's way.

Thanks for the pics. I replied to your email with my phone number. Looks like you have the part I am looking for. Give me a ring.

Can you send me pics of 14 & 15?

[email protected]

Pics sent.

can you send me pictures of the gill exhaust and are they for a trs app. [email protected]

Pics on their way.
Outdrive have little issues with headers.
These will go on any SBC engine.

Thx
P

WTB or trade, two Merc. 454 standard exhaust risers. 4" outlet.
Thx
P

Ill send you an email with pics of the risers I have after bit. Maybe its what your looking for. They are stainless steel factory mercruiser elbows from a freshwater boat. They should be the NLA, 816900A5 and 816900A9.

THanks

I looked up your part numbers, they should work.
PLease confim pics to my E-mail
"[email protected]"

P: pics sent sorry for the delay, computer dead (motherboard) at work today... those parts are as expensive as boat parts!

:) It's ok. No problem. Boats, Computers and Women are all the same. Always need more maintenance and more $. :evilb:

By the way. How about the $'s? you want for a set. (two)
Thx
P

Paradox:
How about $175 PayPal shipped UPS ground with tracking numbers to you for the matched pair as in the pictures I sent you.

You can verify my transaction history by looking at my feedback off ebay... a-m_performance here is the link:

http://feedback.ebay.com/ws/eBayISAP...ab=AllFeedback

Let me know what you think.

Can you send me pics of the SBC headers?
[email protected]

One set of the headers and risers ------ SOLD.

Power steering pump and bracket looking for?

YOU looking for a PS pump?.... or are you asking me if I am looking for one?

I have a PS pump for sale from a 525. no Bracket. 525's don't use brakets. Pump mounts on the block.

Can't get PM's here, so just E-mail.
Thx
P

Bumpetty Bump.
Looks like the headers not sold after all. Buyer vanished. :rolleyes:

Let's just hold on for a minute. Buyer is back. (edited, 12/2/10)

Headers, risers, gone.
Thx

what carb numers

Don't know the size. The numbers stamped in the casting is;
GR -5533 - B

Purchased them to put in a boat that I since sold.
I can E-mail pixs, but can't upload here.
Thx
P

Paradox clean out your inbox.

Sorry Keith, Cleaned up
Drop me a note to "[email protected]"

Thx

TTT.
Some one got to able to use some of these. I need the room.
Offers OK. Please E-mail Can't get PM's

Ttt

What gears for XR is it the Gears with the cone clutch and drive shaft and whats missing. have some parts want to build a spare.

Yes it is. 2007 year. Not much missing, may be some small parts or springs. Look at the Merc. "cut section" for all the part no's.
Attachment 437714

Attachment 437715

Upper driveshaft.
Attachment 437716

Ttt

T T T

sbc headers
 

do you still have the sbc headers if so send picks please [email protected]

Carburetors
 

Can you send pics of carburetors ?
[email protected]

See post, No. 23. Headers are gone.
Carb pix will be sent shortly.
Attachment 442162

Xr parts
 

Paypal on the xr parts ok? Pm me...

Thanks, Glenn

I guess Paypal is OK. I rather just work on a check. I'm not a Paypal guru, but I think I can do it.
Will PM you later.

PM sent Glenn.