offshoreratboy

This is a Gen IV 490 HP 9.5 to1 Compression ratio, short block fresh from the machine shop. All good internals. Forged GM crank, forged rods and forged aluminum SRP pistons .060 over. Short Block built by Jeff Gardener (Gardener Performance) heads are GM square port marine with inconel exhaust valves. Cam numbers are 510 lift with 226 I and 236 E duration @ .050 on a 112 centerline. Manley heavy duty push rods, full roller rockers and Kieth Eichart removable valve covers. There is a lot of goodies on this engine. Hurricane single plane intake and an 830 CFM Sea Demon marine carb. Stainless marine crossover and thermostat housing. Gill 12 Qt. pan. Gill marine exhaust manifolds with TRS pipes with gill wedges installed to get them very close to stock Bravo position. I had these exhaust manifolds on a bravo set up. I had two of these but sold one. Here is your chance to pick up a nice motor cheap! March price goes up! $4800.00 Any questions call Joe 440-585-2002

chaparral2300

Absolutly Speechless, That Is What I Dream About At Night, Lol. I Have A 454 In My Chaparral, I Had A Hack Ass Mechanic Rip Me Off For Close To What Your Asking For That Engine. To Think I Could Have A Race Ready Drop In In That Condition For What I Have Tied Up In My Terd Is Absolutly Sickining Ing Ing Ing Ing

Wow Man, Words Exscape Me. That Would Push My Little 23oo Chaparral Past Its Hull Limits For Sure. What I Would Give For That.

I Have My Engine Listed, In The Event That It Sells, I Can Assure You Ill Most Definefenetly Contact You Asap. As Bad As It Sounds I Hope You Dont Sell It Least Till I Gather The Funds To Get It Myself.

Thanks Steve

chaparral2300

And Your In Ohio, Im In Ohio As Well, Down In Hillsboro Ohio, Your In Cleveland, 5 Hours From Me, Is Sitting The Dream Of Dreams For Me. Gosh Dam. You Dont Need Any Roofing Done Do Ya. Id Do About Anything To Get That Engine. Im A 15 Year Roofer. Any Kind Any One Anywhere Any Roof I Can Do. Id Do Anything For That Engine.

offshoreratboy

Sorry man wish I did...

2tonchevy

just curious....whats the compression ratio on the engine?

offshoreratboy

Compression is 9.5 to 1...Good pump gas.