26p 4 blade Spinelli props
02-10-2011 | 01:16 PM
#2
Registered User
Joined: Dec 2009
Posts: 148
Likes: 0
props
what is the diameter. email pics to [email protected]
where are you located. are the hubs good? what thrust washers are needed to run these?
where are you located. are the hubs good? what thrust washers are needed to run these?
02-10-2011 | 04:14 PM
#4
Thread Starter
Registered
Joined: Mar 2002
Posts: 5,819
Likes: 14
From: cleveland
what is the diameter. email pics to [email protected]
where are you located. are the hubs good? what thrust washers are needed to run these?
where are you located. are the hubs good? what thrust washers are needed to run these?
02-16-2011 | 10:08 PM
#6
Registered User
Joined: Dec 2009
Posts: 148
Likes: 0
still have these props???
I was the first respons to your post, I see that I made a mistake in the E mail address. it is:[email protected]. did you find diameter and have these props been worked on? what rpm could your buddy spin these with 500s and were they carberated?
