Anybody have a decent pair of small block Chevy heads and/or exhaust manifolds laying around you want rid of?
My engine is an '86 and am open to old or new style.
Thanks

I have the stock set of heads off from a 260 that I just upgraded to Vortec's. There from my friends 1986 21 ft scarab. Fresh water boat its whole life with 350 hours. Are you looking for 3", or 4" exhaust parts? I have a set of 3" risers from that boat too.

What are you looking for? 186 double humps with accessory holes and 64CC chambers, vortecs, ect.?

What condition, ready to bolt on or bare?

What's on there now are 76cc chambers don't want to bump the compression up much, if at all.
Open to either style, but they have to have the accessory holes. And would prefer bolt on but if the price is right I can handle the valve job etc.
The exhaust is 4" center riser.
Thanks for the replies

i have a set of barr 4inch manifold and risers and 2inch spacers came of a 1988 350 chevy, used freshwater one season,upraded to aluminum. pm if interested

I have a set of stock heads from a '89 270hp Magnum, and a pair of stock-style Osco "aqua power" manifolds, all in good, ready to use condition. locally listed at $200 for the heads, and $150 for the manifolds, but would do $300 for all + shipping. also have the stock 270hp Holley aluminum intake and carb as well, if interested.

what are the advantages of the vortec heads?

30- 50 horseeeeees depending on intuction system and carb

stock intake and 4 barrel....260hp

They usually are on fuel injected motors on the small blocks.JOHN SR