I have brand new trim tab plates i bought here and they dont fit on my boat. So i want to sell them The part number on them is 891574C . These tabs are for the rams with the rubber grommets in them like a trim cylinder. They are not for the plates with just a pin thru them. You could install bushings and make your cylinder fit if you have the pin type without the gromets. Email me at [email protected] for pics or call me at 267 784 9384.
$ 800.00

how much $

800.00

Sterling. I couldnt email the pics send me your email address again. Reply comes back bad.

i got it, pics were sized to big, you should have the pics now

This is the type i have of the 280s

http://www.mercruiserparts.com/Show_...2F+845588A2%29

And this is the type i have for sale

http://www.mercruiserparts.com/Show_...F+841945A02%29


Look at where the cylinder attaches to the plate. This is the difference as well as the size of the pin holding the plate to the transome plate. You would need to install bushing in this 380 plate for sale.

I was not very aware of the differences when i bough them. I could make them work but it is not a neccesity for me and i could use some cash. I want anyone who is looking at these to be aware of the differences so you dont think it is a direct bolt on for the first type of attachment i listed from mercury .com. Hope this helps everyone looking.

E-mail sent Allicat38

I was doing some research and you can find bushings and the parts to make them work. But i think i am to high on price. I may get all the parts and try them if i cant sell them.


New price is 500.00 firm. If anyone is interested

If you can get me the hook-up on the bushing conversion parts i'll take them

Please send pics to [email protected]
Also need shipping to 85749