Shown here is my Bravo 1 drive (1.5 ratio), dual water pickups (low and side). The side pickups have a few of the orifices blocked off with threaded inserts. The drive has been professionally maintained each year (removed and serviced). Amsoil synthetic gear lube has been used with every change. The zincs were new last year. The drive has never been in the water overnight. The Drive comes with the Stainless Drive shower. I am looking for $1300 plus shipping.

The rams are hynautic. They have no leaks and work perfectly. They might not be pretty, but they work good. I am looking for $250 for both rams plus shipping (new $450 each).

Do you know the yr of the drive? Where are you located?

Sorry, I don't know the year of the drive. It was new on my 2003 Activator (so I would guess pre 2003) based on when the boat was rigged. I am in New York (Long Island). I have the Merc shipping box from the XR I just bought, so I can box it up properly. And it would be no problem for me to bring it to the local Fedex freight terminal if you need it shipped to you.

I have the hydraulic helm & resiveor & bracket to complete the rams. dan (716) 510-4411

what length stroke are the rams
calling dibs if right length

I will try to measure them this afternoon. I recieved a PM last night on the Rams, but nothing is final yet. So the Rams are still available.

Are all rams for single engine boats basically the same length?

No there are 8&9" rams

The Drive is sold!

I measured the rams, and they have a 9" travel. Compressed they are 18.5", full extension is 27.5 (center of the universal eye to the center of the eye on the ram).

Note to self: When you push on the Ram, Oil shoots real far!

are the rams on the table ?
i will buy them
oil or trans fluid came out?


dirty dan, pm'd you about helm and res.