!! Gil manifolds and tails !!
 

I have a set of gil manifolds and tails for sale. They are several seasons old and where used on a 500 Bulldog. They are for a bravo setup. They were also hooked up to Capt. Choice, which is also available.

$1000 for the manifolds and tails
http://i656.photobucket.com/albums/u...a/gilexhst.jpg

http://i656.photobucket.com/albums/u.../gilinside.jpg

I also have an extra set of tails for $300
http://i656.photobucket.com/albums/u.../dadstails.jpg

I'm very interested. Sent you a PM.

replied

Still have?

yes

Can you email me some better pics, mainly of the exhaust flanges and the tailpipe condition..
Salt??

[email protected]

Thanks,
Derek

These are are at my Dad's. That is gasket material on the flange, that he did not clean off. He will send me a new pic after he gets all the material off. These where used in fresh water and the brackish Potomac River.

Did you get my last PM? Please send me the pics also.

Thanks
Allen

PM sent. Pictures too please

More pics as requested. Some of the coating came off at the gasket area so they have been painted. With the proper gasket these will not leak! These are the smooth type manni without the plugs. The two scratch marks above the flanges are from valve cover removal, and one is scratched on the out side from the engine hatch actuator arm. Those marks are not plugs or welds.

this is everything

http://i656.photobucket.com/albums/u...a/DSCN0898.jpg

http://i656.photobucket.com/albums/u...a/DSCN0909.jpg

http://i656.photobucket.com/albums/u...a/DSCN0906.jpg

http://i656.photobucket.com/albums/u...a/DSCN0887.jpg

http://i656.photobucket.com/albums/u...a/DSCN0879.jpg

more of risors

http://i656.photobucket.com/albums/u...a/DSCN0889.jpg

http://i656.photobucket.com/albums/u...a/DSCN0895.jpg

http://i656.photobucket.com/albums/u...a/DSCN0914.jpg

http://i656.photobucket.com/albums/u...a/DSCN0890.jpg

Are all 4 tails the same? Would you sell just the 4 tails??

yes, they are all the same tails. I will seperate. if needed.

bolt pattern on tails is 4 1/4" X 4 1/4". Stanard for Gil

We are interested in the 4 tails and manifolds, give me a call at 573-348-1300.

Thanks,
Derek

Would you sell just the manifolds? I have Gil tails already.

Did you get my PM Sunday?
Brian

Would buy manafolds only,can make payment today.Dan (716) 510-4411

Sorry guys. Have been busy. Everything is sold, to one person.

I updated the thread rather than responding to most PMs.