Im parting my Donzi out. Will leave hull in any rigging wanted. Its a 98 Twin Step 27 Kevlar layup ex race boat with small cuddy. Has a Bravo XR upper and Imco -2 shorty lower with upgraded vert shaft. 380 K Planes or 280 if wanted. HP 500 carbed. Drive and engine 10 to 15 hours max from fresh rebuild. Just a mild cam upgrade was done. Makes 580 fly wheel 600 tq. Serp system acc. drive set up. SX pump with reg billet filter head full hydraulic steering.
Break Down:
K Planes 380- 2500 complete Lines Backings Plates Pumps Rams
Complete Steering- 2800 Helm Rams Fittings Wing Plate Lines Wheel Brackets bolt on ready
Drive - 6000 Bravo XR Upper Imco -2 Shorty lower Heavy vert shaft satin finish new u joints drive shower heavy top cap 15 hours on it
HP Gimbal - 1000 New bellows gimbal bearing inter shift cable top pin slight play
Bolsters - 1000
Trailer 2000- Bill of sale, Just did bearings in it. Tires decent needs lights but will replace if sold. drum breaks tandem
Fuel Pump & Filter Head- 450 Billet filter head M&M and SX 1000 pump 15 hours
Throttle Shifter - 250
Indicators - For twins but use for single right now 300
Water Pick Up - 90
Offshore Mounts - 250 Front and rear Plate
Engine
7500 Long Block
8000- with Carb intake arrestor
8500- Acc & serp system
9200- Exhaust with 2 sets of risers
9300- with harness
9700- turn key drop in
10000- bravo drop in

bolster pics please to [email protected] pic of the boat also please..
thanx

Like to see bolster pics

Throttle Shifter piic lyuba.vitelli@gmail

couple pics can get more if needed

you need to change the bolsters to race side by side bolsters..thanx

Mike if some one buys the power with out the accessories let me know. I would probably want a bunch of the stuff including the belt set up.

Sounds good will do

PM'd you last night right after you started this thread.

I'd mentioned that I'm interested in the drive, bolsters, trim pumps (if you'll separate). What gear ratio in the drive?

Hey ram, it's a 1.50 ratio in drive.