Marine Kinetics Camshaft (Bob Madera)
10-13-2012, 07:26 PM
#1
Registered
Thread Starter
iTrader: (2)
Join Date: May 2012
Location: Gibraltar, MI
Posts: 720
Likes: 0
Received 0 Likes
on
0 Posts
Marine Kinetics Camshaft (Bob Madera)
BRAND NEW: Marine Kinetics Camshaft, new in box and includes distributor gear. Lower duration cam to avoid reversion with shorter risers, but quite a bit of lift. Cam made just under 540 horsepower on my 502 gen V converted to roller set-up with the compression raised to 9.25 and SM manifolds edelbrock intake and 850 holley. This is a cam for a full roller motor. $350 to your door, O.B.O.
Here is what it sounds like in my boat, keeping in mind the pipes are 1/2 in the water.
https://www.dropbox.com/s/walnix0xvk...%2008%20PM.mov
114 Lobe Center
612 Intake Lift/597 Exhaust
226/230 duration @ .050
Email for cam card. [email protected]
I have a duplicate cam in my boat and planned to install this in my brothers formula before he grenaded the engine and bought a complete HP500.
Here is what it sounds like in my boat, keeping in mind the pipes are 1/2 in the water.
https://www.dropbox.com/s/walnix0xvk...%2008%20PM.mov
114 Lobe Center
612 Intake Lift/597 Exhaust
226/230 duration @ .050
Email for cam card. [email protected]
I have a duplicate cam in my boat and planned to install this in my brothers formula before he grenaded the engine and bought a complete HP500.
Last edited by BBCLiberator; 10-13-2012 at 07:35 PM.
