HP gimbal rings and helmets
02-02-2013 | 07:11 AM
#1
Thread Starter
Registered
Joined: Sep 2003
Posts: 332
Likes: 0
From: Lake Erie, Ohio
HP gimbal rings and helmets
I have 1 pair of 2 bolt MERC HP gimbal rings and helmets that came off of my boat. I upgraded to IMCO assemblies.
One ring has a small gouge(see pic), and that set comes with the bellhousing with no studs.
Both sets include the side hidge pins and screws. They both have tight lower bushings and good uppers squares. both are fresh water parts, with good factory painted surfaces.
I used them with drive trim blocks, so the bottom 1 1/2" of the helmets were trimmed(non structural, see pic). Both upper steering pins are tight with very slight pitting.
$500 for the set w/o studs + shipping.
$600 for set w/studs + shipping.
$50ea. extra for steering pin. $25ea. for tiller arm.
LE
One ring has a small gouge(see pic), and that set comes with the bellhousing with no studs.
Both sets include the side hidge pins and screws. They both have tight lower bushings and good uppers squares. both are fresh water parts, with good factory painted surfaces.
I used them with drive trim blocks, so the bottom 1 1/2" of the helmets were trimmed(non structural, see pic). Both upper steering pins are tight with very slight pitting.
$500 for the set w/o studs + shipping.
$600 for set w/studs + shipping.
$50ea. extra for steering pin. $25ea. for tiller arm.
LE
