How much for the steering, lines, fittings?

You looking for the Whole steering system / rams etc. or are you only after parts of it. Id like to sell it all together, Helm, Manifold on transom, pressure container, rams etc. $600 shipped ?

[ATTACH=CONFIG]514033[/ATTACH][ATTACH=CONFIG]514034[/ATTACH][ATTACH=CONFIG]514035[/ATTACH]

I'm interested in the entire system minus steering wheel. I am a lil concerned over your air over hydraulic statement.....as this is nothing I have ever heard of at the helm.....but I have a hydraulic INTERNAL setup now

Well I am not , real, familiar with this setup, I beleive the main deal being it doesnt use a power steering pump, the pressure is provided by the pot with air on it. It has a schrader valve and a specific amount of fluid, is in the reservoir along with a certain amount of air pressure on top of it. I do not know the appropriate way to hook it up if you were trying to use a power steering pump . Or if it could be done. You mentioned a hydraulic INTERNAL setup right now, I am assuming you are speaking of a standard power rack attached to the inside of the transom plate, steering the system with the steering arm inside the boat? I wouldnt know of any other ways to run this system than the way it is. Maybe others know more about it, the rams are small diameter rods, so not a lot of fluid in comparison to others.

$800, for the pair complete with trim rams etc. Plus freight.

I know it's a long shot because this thread is old but I'd be interested in both the external steering rams (depending on length). Please let me know if they are atill available. Thanks!

Not too long of a shot, Yes i still have them and the transom assemblies, I can attempt to measure them, I assume you saw the photos, Do you need the whole setup, with the helm pump valving and lines etc. my email is [email protected]