Very informative Saxman.... All bs aside though, it's pretty cool that you can walk to your garage and find that kind of hardware.

Quit dicking around here KC and get your OE finished!!! Lol. Merry Christmas bud

lmao, After I saw your comment, I had to double check to make sure I didn't post the wrong pics!

WTF????? The Donzi 16 doesn't need these!

So they are 12" to the top of the dominator adapter plate? What is the IC thickness?

Thanks!

There are two plates on top of the PSI. The first plate is used to cut your inlet hole(s) to the rotors (10.75" to the top of this plate, what is normally referred to as the top of the blower). Then you add the carb adapter plate on top of that, which can be vary in thicknesses, depending on if you make your own, or who's you buy.

The intercooler case is 5". The intercoolers Doug bought from us also have an integrated PSI adapter plate. Here are some more specs and pics on our coolers www.pfintercoolers.com

I need to run with the Checkmate the TG's this season... I'm thinking quad rotor PSI on the LS1 should come close!

Maybe I should have asked, what's the dimension from the base of the IC to the top of the dominator adapter plate for this exact setup that's being listed here??? I need to check my clearances... Thanks

Should be 11.5" including the carb adapter, but that's assuming Dougs carb adapter is 3/4" thick. You'll have to verify with Doug.