Bravo one drive trim pump hoses,no leak and not striped,30.00
Tilton start,new rebuilt by Tilton, 200.00
Tilton starter solenoid , new 30.00 each,1 used 20.00
Preluber relay controler, 25.00
Whipple 500efi blower belts,VG 15.00 each
Comp cams 929 springs, tested 145 at 1.880, 25.00,one set with retainers 35.00
500efi macathode pos wire, 5.00 each
Tilton starter block mount,alum, new 25.00 each

all are each and plus shipping,usa only

Thanks
Rob

I will trade for some 4blade bravoone 28's or 30's, or 28max

Hustler pass side dash alum /step, 20.00
Gen 5 6 Felpro valve cover orings , 10.00 a set
Felpro valve guide seals, 5.00 a set
Bravo one impeler bolts, 10.00
Bat isolator ,used 20.00
Stainless brake sili dot 5 fluid, 20.00 both
Barrygrant carb to aircleaner seal, 5.00 each
Nitrousworks/Barrygrant NOS plate, 20.00 or use it as a carb spacer
K&N motorcycle filters.new 40.00
Felpro sbc valve cover gaskets 10.00 each set

Manley sbc head bolts, 15.00
BG fuel pump, 150.00
B&M trans temp gauge w/ new sender. 25.00
SBC raised/hardened guide plates, 8.00
Manley sbc timing chainset, 10.00
Manley sbc oilpump pickup 10.00

Are the trim pump lines pliable? Mine are hard from age & I don't want to crack them with my new build. If so I will take them. Randy

I wouldn't say they are hard,buy they do have a curve to them from being in my boat,they are 2001 and I replaced them in 2008,I can take some more picks if you want?

the merc cathode wires thingy mo dickers, are the they ones from the starter fuse to the top ?? if so put two in the mail to me, how do you need paid

hustler/Sony cd changer 50.00
Holley carb regulator plate, 10.00
Engine stand/hoist swivel wheels/caster. 5.00 each
antique Garcia Abu-matis fishing reel, 30.00 each
Ruger 10/22 scope rings and base, 15.00

Old air brush kit, 10.00
Pioneer Crossovers,2-5.00
New rifle case,25.00
commercial grade buffing wheels, 8.00 each


[ATTACH=CONFIG]519869[/ATTACH][ATTACH=CONFIG]519868[/ATTACH][ATTACH=CONFIG]519867[/ATTACH][ATTACH=CONFIG]519866[/ATTACH][ATTACH=CONFIG]519870[/ATTACH]

Littlefield 8/71 competition blower snout w/ hub.it was a rear set back big block,its around 7in,some call it 6.900 or 7.100,,
has 75 hours on it, it has some marks were the idler/swing arm clamped on it. 275.00

I will trade for some 8mm pulleys from 49-44


[ATTACH=CONFIG]519882[/ATTACH][ATTACH=CONFIG]519877[/ATTACH][ATTACH=CONFIG]519878[/ATTACH][ATTACH=CONFIG]519880[/ATTACH][ATTACH=CONFIG]519881[/ATTACH][ATTACH=CONFIG]519883[/ATTACH]

i think so, il try and get the part no off it

I'll take the vintage air brush kit.

Sending you a pm.

Thanks