Have a couple of sets of valve springs...

I rebuilt the top ends on my 525EFI's before this past season and it turns out I did not use the right springs. I am now replacing those so have a few sets.


(1) Set of Comp 929 springs.. used for 20 hours. These came on a new long block that I replaced in August 2014, they were run on the rebuilt engine for 20 hours and were replaced when I did the top end refresh. Pretty much good as new.. $75 plus shipping.

(3) sets of Isky 9905 Tool Room springs.. these are very high quality springs but just have too much seat/open pressure for a stock 525EFI application. These were run on my motors for 50 hours. $200 / set plus shipping. I have one set available right now and the other two will be available within the next two weeks.

PM if interested. Thanks.

Ttt

Sounds like you're packing it in after the Hudson River Run.

Yup. I'm done. Winterizing when I get the chance in the next few weeks. My boat stays indoors all winter but I still winterize her anyway...

BTW... all three sets of Isky springs are available now..

Been following the Hudson River Run. Sounds like everyone had a great day. That's good to hear although I was a little jealous as I would have loved to have been there. I know that area is beautiful this time of year and looks like y'all had a great group.

Yeah, it really was a great day. It was chilly but the scenery was beautiful and there was a great turnout (50+ boats) for a fall day in 50's. It was well organized, the venue / food were great and everyone really had a nice time.

Ttt