highplainsdrifter

This motor has only been run long enough to set the timing. I decided to go a different direction. 5k firm plus shipping. If you want it run on a dyno, I'll drop off and pick it up at no cost, you pay for dyno time which is probably 700-800 dollars.

Brand New, not refurbished L31 short block
Canton Racing products 7 qt oil pan with Fel Pro Marine gasket
Melling 155 oil pump with Canton oil pickup
Edelbrock E-Tec 170 Aluminum heads
Comp Cams Ultra Pro Magnum full roller rocker arms
Comp Cams Magnum pushrods
Comp Cams XM270HR roller cam shaft
OEM Chevrolet roller lifters
ARP Head studs
Fel Pro Marine Head Gaskets
Edelbrock Performer instake manifold
Cloyes high performance true roller timing set
Polished Aluminum EMI Thunder Exhaust manifolds
Edelbrock 600 marine carb
Davis Unified Ignition

Can come with either an aluminum Edelbrock water pump or a Stainless marine crossover setup. The only thing that should be done is to replace the freeze plugs with brass ones. I was planning on running closed cooling, so I didn't do it. I'l include them with the engine, but they will need to be installed.