I have 2 IMCO SC steering caps that have two ears that both point to on side. They are setup to be run with twin rams and a connecting bar. They are black and in good condition. I'm looking to trade for set of AEC-7 steering caps that are setup for use in a single engine setup. Pictured below is what I'm looking for. PM me or text at 810-240-2580. Andrew

Can you post the pictures of the one you have because it sounds like I need yours and you need mine

mine have the mounting on each side it just does not have the center hole as in the pictures above

Here is what mine look like. I can get pictures of my actual ones by the end of the day. But these look identical to the ones I have. The double ears should be fine with or without the center hole.

The bottom pic is different then the top pic. The ones I could use are the top ones. Which do you have?

I have the top ones.

I’ll take a pic of what I have tomorrow and post it

sounds good

These are the imco back caps I have the pins/bolts however since I have Latham rams I had to have them machined to fit the smaller Clevis ,until I found the correct bushinged imco style clevis . The pic below is how I currently have it set up with the saddles which I do not want to use this way I’d prefer to have them all mounted to the imco caps .

Those caps look like they will work. How would you like to set up this trade?

Your pm box is full.