|
mercury 496 8.1 HO
2- mercury marine , 496, 8.1 Ho , complete drop in engines , stainless marine exhaust manifolds , (no tail pipes),new starters , fresh
https://cimg1.ibsrv.net/gimg/www.off...2a219225dd.jpg service , about 320 hours asking $21k for the pair , not ready to split up . [email protected] |
What are torque numbers on these Bob and where are they in FL?
|
My 496 MAG (non HO) made over 500 ft. lbs. after a rebuild (totally stock other than .030 over pistons). Can't find the dyno sheet so I can't tell you at what RPM. Bob Llyod has posted dyno sheets before on this site. I'll see if I can find them.
|
Throttleman - I sent you message. Check it out when you get a chance or call me.
|
Originally Posted by Swamplizard
(Post 4861548)
What are torque numbers on these Bob and where are they in FL?
https://www.raylarengineering.com/me...e-article.html |
did not run them on the dyno , there totally stock ,
|
Sold.
|
| All times are GMT -5. The time now is 09:10 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.