2- mercury marine , 496, 8.1 Ho , complete drop in engines , stainless marine exhaust manifolds , (no tail pipes),new starters , fresh

service , about 320 hours asking $21k for the pair , not ready to split up . [email protected]

What are torque numbers on these Bob and where are they in FL?

My 496 MAG (non HO) made over 500 ft. lbs. after a rebuild (totally stock other than .030 over pistons). Can't find the dyno sheet so I can't tell you at what RPM. Bob Llyod has posted dyno sheets before on this site. I'll see if I can find them.

Throttleman - I sent you message. Check it out when you get a chance or call me.

See here:
https://www.raylarengineering.com/me...e-article.html

did not run them on the dyno , there totally stock ,

Sold.