They aren't but I measured and they are really close. THe problem is that I can't tell exactly what the angle of the rubber hose was????

There is not really a lot of room under the swim platform to move around. They are either gonna work or they ain't. I am cutting the holes tomorrow and cross my fingers.

I should have about 3/8" margin of error all the way around. KC (the guy I got them from) said that on his boat they were a little lower than stock, but who knows if Velocity and Nortech used the same exhaust template when they cut the original holes??

Are the Stellings headers and tails set up for standard bravo?

You gotta know that just as soon as I start making progress, It looks like we might have to saddle up and go to work. This could get ugly.

These are. KC spent a bunch of money having them made that way. He said they missed a little low though when they came back from Stelling. I hope they did, because, otherwise I will have to cut fiberglass out of the bottom of the swim platform.

work just another four letter word....

[YOUTUBE]http://www.youtube.com/watch?v=vyN8V...eature=related[/YOUTUBE]

A YOB ain't nothin but work.

Correction, I said "fat ice man"

Brody will be ready to put some throttles in his hand soon

Who's his daddy? He is all ready bigger than you.