The B.S. Thread
10-19-2010 | 03:47 PM
Thread Starter
Social Distortion
Joined: Sep 2004
Posts: 5,728
Likes: 6
From: Lake Conroe,Texas
I have been calling around a little for Sunday. I talked to skinney Kenny, They are doing some maintenance on his rig and he will beout of town saturday, but he said he is probably in for Sunday. Talked to Wayland and if his old lady will tell him where she hid the keys, he is in.
I was thinking maybe we could finally get both the Stutlz boys in the water on the same day for once. Get cornbread to get his boat out.
Ramrstrong has been itching to get his rig in the water for months now. Maybe this will get him over the edge. I can probably get bill and willis involved. I bet we can get more boats for this deal than a usuall TOPPS event.
I was thinking maybe we could finally get both the Stutlz boys in the water on the same day for once. Get cornbread to get his boat out.
Ramrstrong has been itching to get his rig in the water for months now. Maybe this will get him over the edge. I can probably get bill and willis involved. I bet we can get more boats for this deal than a usuall TOPPS event.
10-19-2010 | 08:33 PM
Thread Starter
Social Distortion
Joined: Sep 2004
Posts: 5,728
Likes: 6
From: Lake Conroe,Texas
10-20-2010 | 12:10 AM
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
It will go in Thursday for a run in on friday probably and try and get interior in and hook everything up in the cockpit saturday. It is going to be a real tight schedule to try and get it in the water sunday, but at least there will be plenty of boats to tow me in and make fun while it is happeneing.
I think it is going to be a runner though.
They didn't have enough fittings in stock at huffco (sp?) to make the oil lines so nothing major hapened today. The cooler is in for the ports side and the exhaust holes adjusted. Still need to resin up the holes to seal them off. Should have starboard running tomorrow, and button up wiring etc on port.
Good progress on her from Hodges custom rigging.
I am going to get him a hat that says "head rigger in charge""
I think it is going to be a runner though.
They didn't have enough fittings in stock at huffco (sp?) to make the oil lines so nothing major hapened today. The cooler is in for the ports side and the exhaust holes adjusted. Still need to resin up the holes to seal them off. Should have starboard running tomorrow, and button up wiring etc on port.
Good progress on her from Hodges custom rigging.
I am going to get him a hat that says "head rigger in charge""
10-20-2010 | 10:08 AM
Registered
Joined: Aug 2004
Posts: 4,227
Likes: 0
From: FORTLAUDERDALE, FLORIDA
10-20-2010 | 12:52 PM
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
10-20-2010 | 02:31 PM
Registered
Joined: Jan 2006
Posts: 2,310
Likes: 0
From: Lake Conroe TX
