Originally Posted by Velocity Vector

I'm going to sweeten the thread a little. Tell a friend, Winner gets a $100.00!

Look at the parts listed below: ??? POST>>How much is it going to cost for just the labor turn Key??? Taken out the old and putting in the new I want you guy's to take an edcuated guess on how much the labor will end up costing on the project, all I can say is it is $95.00 per hr.

To make it fair I'm staying out. When I get the final bill I will post the winner. Good Luck hope you win!
One guess and make it a good'en

3 Rules:
1. If you go over the total your guess doesn't count!
2. If for some reason there is a tie the earler post will win.
3. Once your $$$ guess is posted you can not edit it. VV

If you make a error in the post let me know and I will change it and re-post it here. All money amounts are in U.S. DOLLARS VV

2 - Mercury Supercat race engines $29,000.00
2 - Weldon 1000 HP Fuel pumps $1,400.00
2 – Regulators w/ by-pass Areomotive $500.00
2 - Oil coolers & brackets $500.00
2 - Keith E. Oil pre-lubers $1,400.00
2 - Hardin Marine water separators $440.00
2 - MSD Marine distributors $780.00
2 - MSD high vibration coils $100.00
2 - MDS coil brackets $10.00
2 - MSD sets rpm chips $132.00
2 - MSD insulated plug wires $200.00
2 - Stellings headers $13,000.00
2 - Stellings tailpipes $3,000.00
2 - Air activated switchable mufflers $2,400.00
2 – Hour meter Gauges Livorsi $100.00
2 - Xtreme Billet Aluminum Engine Mounts Rear Side By Side Mount $600.00
2 - Xtreme Billet Aluminum Engine Mounts Front Side By Side Mount $880.00
2 - Billet Aluminum Xtreme MSD 6M-2, Rev Limter & Coil Bracket $270.00
2 - Billet Aluminum Chevy Distributor Hold Down Clamp $80.00
2 - Throttle Bracket King Demon Carburetors $95.00
2 – Wiring harness $278.00


2 - Mercury XR race drives W/ 1" shorties $13,000.00
2 - 15.25 X 34P Mercury Marine props $1,500.00
2 - IMCO 12" Extension boxes $8,000.00
1 - IMCO Tie bars Lower $379.00
2 – IMCO HD gimbal rings and helmets $2,700.00
2 - K-Plane 380 plates $1,800.00
2 - K-plane pumps $500.00
2 - Trim pumps $500.00
4 - Billet 42oz. reserve fluid reservoirs $800.00
2 - Rule 2000 bilge pump $310.00
2 - Dual billet trim reservoirs for pumps Dana Marine $900.00
3 - Billet battery boxes Dana Marine $400.00
2 – XR Drive actuators $548.00
2 – XR drive locks $60.00
2 – Prop Locks $72.00


1 - Piratecom 5 person intercom system W/extreme headsets $2000.00
1 - VHF Radio $585.00
1 - VHF Remote microphone $160.00
1 - VHF antenna $100.00
1 - Ratchet mount $25.00
1 - VHF radio flush mount $25.00
1 - Go Pro video camera $170.00

Originally Posted by TexomaPowerboater

Let me know if your going to be testing the boat on a weekend. I'd like to see those numbers rather than reading about them Maybe even snap some running pics. The apache is broken down, but I could get some good shots out on the water with the sea ray.

Originally Posted by DKerns

Well............... Any updates?

Originally Posted by Velocity Vector

Pray with me, not yet.
http://www.youtube.com/watch?v=QezIBLK5WHg