Dry headers for TRS set up.......
Looking for two sets of dry headers for a trs set up.......
|
headers
I got 2 sets of gill's with dry pipes for trs's. Two of the pipes need a small weld job.Gil said it would cost 300.00.The stuff does not have much time on it,fresh water.I'll take 3500 for it all. manifolds look like new. Thanks JOHN
|
i dont think what you have will work because i have the gill dry manifolds also and when i went to install the motors today i noticed theyre too wide for my setup and they are going to hit in the middle of the boat......so i think i need headers to give me some more room to clear between the two motors.......
|
Not sure how much more clearance you need but if its not a whole lot you coud always consider having the flanges of your Gil's milled dow a bit...... Just a thought & would save some $$
|
All times are GMT -5. The time now is 07:58 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.