Looking for two sets of dry headers for a trs set up.......

I got 2 sets of gill's with dry pipes for trs's. Two of the pipes need a small weld job.Gil said it would cost 300.00.The stuff does not have much time on it,fresh water.I'll take 3500 for it all. manifolds look like new. Thanks JOHN

i dont think what you have will work because i have the gill dry manifolds also and when i went to install the motors today i noticed theyre too wide for my setup and they are going to hit in the middle of the boat......so i think i need headers to give me some more room to clear between the two motors.......

Stainless makes them for side by side with a 34 centerline.
Hightorgeu III
call brownie @stainless marine.

Not sure how much more clearance you need but if its not a whole lot you coud always consider having the flanges of your Gil's milled dow a bit...... Just a thought & would save some $$