I'm looking for a set of tail pipe wedges (2 wedges total) for a 1 set of Gil Manifolds.. They are standard 4" exhaust with the square flange at the manifold & tailpipe joint.

I really need them atleast 1/8" - 3/4" taper..

Thanks, Scott

check in the morning ...might have them

Sounds good & I appreciate you checking.. You may or may not remember but I bough a pair of optima holdowns from you several years back.. ;-)

Ya man they were kinda blue ....see pics below I think these might fill your need ...

They have since been de-blued & are kinda polished & looking purdy sweet now..

Is the top pic you posted a view of the tappered side ? Ifso they will not have enough taper for my need.. They need to have atleast 5/8 taper from one end to the other.. Any idea how tall those are on each end ?

Woe thats a sh#$t ton of taper....did not notice specs in first post ......these are about 1/4-1/8 taper....glad to hear the boxes worked out though

Yeah my tails have maybe 1/4-1/2 drop from flange to tip.. It wouldn't be an issue since they are dry, however the top portion of them are aiming a bit to much at my rubrail..

Thanks for taking the time to get them out.. I would have been more than glad to buy a set from you as you were easy to deal with before..

I've got a set that are a little beat up. You can have them if they'll work for you. email me your address to [email protected] and I'll send them out to you.

Doing that now !!! Wow, just another reason I love this place !!

Just got back from the post office... THANKS again bro !!! Talk to you soon..