Offshoreonly.com - (2) 1050 dom carbs and 2 std deck intakes.......

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Wanted (https://www.offshoreonly.com/forums/wanted-244/)

- - (2) 1050 dom carbs and 2 std deck intakes....... (https://www.offshoreonly.com/forums/wanted/243967-2-1050-dom-carbs-2-std-deck-intakes.html)

Quote:

Originally Posted by CcanDo (Post 3313345)

We have a set of 1050's and a set of tall deck (10.2") Wilson intakes, w/turtles, ported and polished. Exterior is mill finish Aluminum. There are more pcs. to the package, though not sure what they are. The parts are in box's under other box's.

Subject to your interest, we will move those box's around. The books show we have $3008.00 in those parts.

BTW, The intakes were sent to Wilson for installation of steam bungs at the rear of the intake. They are still in the box's.

These intakes will work on your short deck w/shims. Your distributor shaft may be short, unless it is adjustable. These intakes will probably flow much better than a short deck intake. Some tuners prefer to use a tall deck manifold w/shims on a short deck. Hatch clearance would be the only concern.

This is corrected: The shims are used when using a short deck manifold on a tall deck block. Tall Deck manifold to a short deck block will probably require machining bottom flange for angle change. Benifits stated, should remain.
Sorry for the confusion.

i have some questions about your exhaust also after reading your resto thread. give me a call 860-302-3410.

i have two new merlin x intakes
the ones with the brass intakes
600 for the pair never been out of the boxes

I have a pair of 1050s, there here in the swap somewhere, there used looking for 750 for the pair.

arent your carbs set up for blowers?

I've got a set of standard deck intakes and 1050's are you still looking?]

Dave

nope got them from velocity vector. thank you though