Looking for 2 sets of pushrods for gen6 502s with adjustable rockers wonderful machine shop I chose to freshen them returned them to me without pushrods, and missing one set of guide plates not going to argue with them over it. Trying not to spend $300 on 2 new sets

I have 2 sets, aftermarket out of my gen 6 HP500's. 1 set is out the other will be out Monday. I will pm you the size that is laser etched on them tomorrow to see if they will work for you. They have @20 hours. $200 shipped to you.

PM me your address and I will send you a set of guide plates.
Just send me postage when you receive them.

What length pushrods? If I have them I will send them also.

I have three different sets of Push Rods for a Gen 6 502. All are new/never run.
#1) Stock GMPP 3/8 .080 wall
#2) Trend 3/8 .130 wall
#3) Trend 3/8 .130 wall

If you list what length you need, I will see if they match what I have. All available in double sets too.
Also have two sets of GMPP (Crane makes them for GMPP) 1.7 roller rockers. Again new/never run.
Since I did not use the guide plates, I will toss them in at N/C. BTW: The Trend rods are the finest available.

I have a nice take out set out of an HP500 (7.550 and 8.550)

This doesn't sound so good......

all good paul, smokin gun had some i picked them up and finished one motor yesterday and working on the other today

rookie thank you, pretty sure i'm all set though smokin gun had everything i needed, and is local, well 90 miles away lol