Bennett ST12 Trim Tab Plates/Trade for ST16?
04-28-2012 | 05:46 PM
#1
Thread Starter
Registered
Joined: Jan 2010
Posts: 53
Likes: 0
From: Iowa
Bennett ST12 Trim Tab Plates/Trade for ST16?
Looking for some st12 dual ram plates only. Purchased some ST16 which are gonna be too long, will trade as well.
Last edited by hopper75; 04-28-2012 at 06:33 PM.
05-02-2012 | 09:54 PM
#3
Forum Regulator
Joined: May 2001
Posts: 24,210
Likes: 1,604
From: Worldwide
I went from 12s to 16s on my Sonic, many years ago. I was able to notice the improvement. Why do you think they are too long?
The 16s come with a mounting plate for the transom with 2 rows of screws vs. 1 row that comes with the 12s. I do not recommend going to to the 16s without the stronger/bigger transom plates.
I don't think the tabs themselves would run you more than a couple hundred bucks from Bennett direct. This would be the route I would take.
The 16s come with a mounting plate for the transom with 2 rows of screws vs. 1 row that comes with the 12s. I do not recommend going to to the 16s without the stronger/bigger transom plates.
I don't think the tabs themselves would run you more than a couple hundred bucks from Bennett direct. This would be the route I would take.
05-02-2012 | 10:07 PM
#4
Thread Starter
Registered
Joined: Jan 2010
Posts: 53
Likes: 0
From: Iowa
Actually looking to downsize, purchased some st16's on OSO and after a dry setup my swim ladder is going to rest right on top of the port tab at neutral, not a huge deal but I thought I'd see if anyone was interested.
