This forums quote machine is broken lol

Spacers
 

I have a pair of 1" spacers that came off #5's if they will work.

Not sure if those will work on a iv with the polygon shafts. Ill have to ask around about that. Never messed with the spacer stuff on these drives

The #5 spacer's will work the difference is the tilt pin hole on the #4 is 7/8 and the #5 is 1" you can use a bushing or get a 1" tilt pin.I have the 2" spacer if you guy's need them.I don't have the studs for the 2" spacer at this time but I can get them if you need them,they are expensive from mercury.

trim pins
 

You can use a section of 1" od stainless tubing, approx. 1/4" shorter than the length of the hole in the #5 2" spacer, to make up the difference between the #4 7/8" pin and the 1" hole that is in a #5 spacer. Also if you want longer studs for either a 1" or a 2" or a 3" spacer you can buy longer ss bolts, cut off the hex. end and thread either fine or course threads to make new longer "studs" for a lot less than Mercury wants for their studs. I know that both of the above work as I have done both.
Call me if you want more help.
Gary
612-247-7081

Can you guys point me in the right direction for the studs from Mercury?