Need. Tail stock for TRS setup. Installed two plugs in mine in three years, still leaking transmission fluid 252-339-4560

I have one. But why not just pull your tail stock off and replace the lip seal in it?

Ok I reread, not sure what plugs your referring to.

Pull your drive and look into tail stock, you will see a plug in it. When you install drive the shaft stops just before the plug. When plug comes lose it allows fluid in seep into bellows and past the seal and leak down transnom .

Maybe I'm missing it be don't see a plug. If your interested in this one it needs new bushings and a rear bearing, make offer, never leaked
[ATTACH=CONFIG]525618[/ATTACH][ATTACH=CONFIG]525619[/ATTACH][ATTACH=CONFIG]525618[/ATTACH][ATTACH=CONFIG]525622[/ATTACH]

[ATTACH=CONFIG]525633[/ATTACH]

I think I have one , will check tomorrow.

What I really need is the short shaft with bearing on it that goes into back of transmission that the tailstock bolts against. Ant old transmission out there.

Clean bothe surfaces with brake Kleen then Put red lock title on the plug and press it in

Should hold

Mark