Need extension driveshaft for imco box xr drive

You're going to need to know your bearing cap diameter of the u joint on your drive

Let me know if you have grease-able u-joints or the non- grease-able u-joints. I have two imco input shafts but I'm pretty sure the are for the older style XR u-joints.

greaseable my xr is probably 8 or so years old it has the c clips on the inside of u joint

still looking

I don't know if we spoke or not about this. But the ones that I have are for the standard bravo u-joints. HOWEVER, I also have a complete IMCO XR input assembly out of an IMCO SC drive. The IMCO uses standard bravo u-joints. If you are interested I'll swap you your XR input for the IMCO input, plus $350 for the extension shaft, and you will be good to go. The shaft assembly is all IMCO and not merc, and will work on X and XR pinions. The gear end, u-joints, and yoke, are all in near new shape. The extention shaft is in very good condition. Let me know if you are interested.

I sent you a pm with my phone number