in the 320-360cc range , bare is fine.. no junk or salt water or old

I have 2 pair of heads from a 1999 HP 500. Stock except for springs replace with comp 929's at 350ish hours. 625-650 total hours. Make me an offer I can't refuse.

Mark

I should have specified blown application 1000hp ..

Aluminum or Steel? Just stock no port work? I know JimV (Valako) just had a few sets of Promaxx 317 and 340 CNC dropped off. They might be spoken for but they seem to be supplying him with bare castings regularly. Let me know if you want to get in touch with him.

I don`t care either way .

Good to know thou . I was also looking at the Flotek , with a blower cnc isn`t necessary but nice. I got Big AL looking into the the flowmaxx units ..

I’ll text you at a reasonable hour. I have 2 sets of cnc’d darts. With shaft rockers, etc.

Jimmy Valako has some down there , give him a call Jimmy is Honest as the day is Looooong 616-889-0928

I have in stock BRODIX HEADS
Race-Rite 270
Race-Rite 340
Dragon Slayer 320
Dragon Slayer 365

Perhaps you missed this part of Dan Dans post :::::::: no junk or salt water or old

What in JD's post makes you surmise what he has are junk or salt water or old?
I'm surely missing anything obvious.