Tie bar
 

I have a 32' . Need at least 36"

What diameter are you looking for? I believe I have one laying around, but I think it was for a Bravo boat. Maybe 13/16" thread LH-RH,

Something in the 1.50-1.75" diameter range..

I know a local marina went to a prop repair shop that supplied shafts to the inboard cruiser market...
The shop made the center section of the tie-bar from a cut off from a previous prop shaft job and cut the threads for the clevis' ends... a lot cheaper and faster than ordering a tie bar assembly as its just basic machining to punch the order out the door.

Something to consider..

Another one to look at is Zeiger Performance Marine. (Located in Sandusky, OH)

Speedmaster 6 Tie Bars & Mounts @ Everett Performance - Zeiger Marine Products Official Site

Morning, I have a Latham 36" when fully closed off an ITS system.
https://cimg7.ibsrv.net/gimg/www.off...b63914b4e0.jpg
https://cimg9.ibsrv.net/gimg/www.off...083d0e33e2.jpg
https://cimg0.ibsrv.net/gimg/www.off...bcb98d0550.jpg
https://cimg4.ibsrv.net/gimg/www.off...1c755bd2f6.jpg