Bravo Top Cap
04-28-2026 | 12:21 PM
#21
Thread Starter
VIP Member
Joined: Jun 2021
Posts: 3,532
Likes: 2,137
From: SW Ohio
The wags engineering one are fully water cooled, and then it dumps onto tye side of the case. I have a set and I can send ya a pic when I think if it. Definitely is a nice piece of work….and that’s coming from a machinist as well. I’m not sure if he still makes’em or not but if i remember right he went by wags382 on this site
I keep hearing about the mythical beast, but have yet to lay eyes on one of them. Please do post a pic if/when you get a chance.
Thanks. Brad.
04-29-2026 | 04:45 AM
#23
Registered
Joined: Nov 2004
Posts: 14,140
Likes: 3,706
From: On A Dirt Floor
Good find ! ^^^^
There are a Few photos of the cap on his facebook page:
https://www.facebook.com/100057343694420/
I wonder if Wags is still with us. Years back, He used to have a bunch of parts on Ebay. Haven’t seen’m listed fir a long time.
There are a Few photos of the cap on his facebook page:
https://www.facebook.com/100057343694420/
I wonder if Wags is still with us. Years back, He used to have a bunch of parts on Ebay. Haven’t seen’m listed fir a long time.
Last edited by SB; 04-29-2026 at 04:47 AM.
04-30-2026 | 05:12 PM
#24
Registered
Joined: Aug 2007
Posts: 266
Likes: 5
From: marquette, mi
Say what ya want but after being on my boat seasonally slipped for 6 years and exposed to 10tons of duck **** and harsh cleaners whoever did his anodizing I’ll give a pat on the back to as well, these caps are 15? Years old
Last edited by halfgassed; 04-30-2026 at 05:21 PM.
04-30-2026 | 05:28 PM
#26
Thread Starter
VIP Member
Joined: Jun 2021
Posts: 3,532
Likes: 2,137
From: SW Ohio
Anodizing should hold up pretty well, being an electrochemical penetrant process. It’s paint and powder coating that will suffer over time.
Thanks. Brad.
05-01-2026 | 06:48 AM
#27
Thread Starter
VIP Member
Joined: Jun 2021
Posts: 3,532
Likes: 2,137
From: SW Ohio
05-02-2026 | 09:16 AM
#28
Registered
Joined: Aug 2007
Posts: 266
Likes: 5
From: marquette, mi
