The 3 man is getting some mney dumped into her
#201
Registered
Joined: Mar 2005
Posts: 3,927
Likes: 2
From: Montgomery, Texas
#202
Registered
Joined: Mar 2005
Posts: 3,927
Likes: 2
From: Montgomery, Texas
#203
Thread Starter
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
#205
Thread Starter
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
Bringing this back to life. Front of the engine is all dressed for the prom except for the power steering. Still a few water and oil lines to sort out on the back of the engine.
Now we are concentrating on sea strainer and oil cooler mounting. Have an adjustable pick up coming from Eickert's and a pressure relief valve.
This boat will be bringing water in from 2 inlets for the 2 stage pump. One from the low water pickup on the bravo to also help keep it cooler and healthy longer. THe other from a low water pickup through the transom.
Hopefully should see some progress in that dept later this week and over the weekend.
Now we are concentrating on sea strainer and oil cooler mounting. Have an adjustable pick up coming from Eickert's and a pressure relief valve.
This boat will be bringing water in from 2 inlets for the 2 stage pump. One from the low water pickup on the bravo to also help keep it cooler and healthy longer. THe other from a low water pickup through the transom.
Hopefully should see some progress in that dept later this week and over the weekend.
#208
Thread Starter
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
Engine is almost all wired. Need to shrink wrap the wires, and get her all gussied up. Need a set of started bolts and a sending unit and she will be ready for a test run on the ground to see if there are any leaks or electrical issues and then hopefully a stab this weekend.
Starting to gain some ground on this project after how long. I need to go back to the beginning of the thread and see how long this has been going on. Way to long.
Starting to gain some ground on this project after how long. I need to go back to the beginning of the thread and see how long this has been going on. Way to long.
#209
Thread Starter
Registered
Joined: Jun 2006
Posts: 14,914
Likes: 1
From: Lake Conroe, TX.
Engine is finished, Got sea strainer bolted in before I had to leave town again. Need to finish the plumbing and mount the oil cooler and then the engine can go in. Then it is just the little stuff to get her ready to go.
The dream is to have her ready for sunny isle's but work may get in the way. The plan was to sell it after she made it to Bimini and back (so I could say I did it).
The question is, Does anyone want this boat either finished or in the condition that it is in??
PM me and let me know. We can discuss.
Liqidating everything that is boating related. Getting started on a new house.
The dream is to have her ready for sunny isle's but work may get in the way. The plan was to sell it after she made it to Bimini and back (so I could say I did it).
The question is, Does anyone want this boat either finished or in the condition that it is in??
PM me and let me know. We can discuss.
Liqidating everything that is boating related. Getting started on a new house.
Thread
Thread Starter
Forum
Replies
Last Post
boot
General Boating Discussion
26
06-08-2004 08:03 AM





