Converting another boater into an Arneson Believer
#62
arneson-industries.com
Offshoreonly Advertiser
Thread Starter
..? So the Arnesons are responsible for the performance of a boat with a different power supply in your comparison? Sorry but that's not what this thread is about..
__________________
Arneson Surface Drives www.arneson-industries.com
Arneson Surface Drives www.arneson-industries.com
#63
Registered
iTrader: (1)
725 Ilmor's & 700 Merc's are not exact but pretty equal. With the claims you make the Arenson boat should have been faster, no? I was just asking a simple question on why it didn't seem to work as well on the Fountain. Could be many reasons, sorry for wanting to be more knowledgeable about your product. No reason to be a d*ck about it!
Last edited by jmoore1225; 12-19-2015 at 02:57 PM.
#64
Registered
725 Ilmor's & 700 Merc's are not exact but pretty equal. With the claims you make the Arenson boat should have been faster, no? I was just asking a simple question on why it didn't seem to work as well on the Fountain. Could be many reasons, sorry for wanting to be more knowledgeable about your product. No reason to be a d*ck about it!
#65
725 Ilmor's & 700 Merc's are not exact but pretty equal. With the claims you make the Arenson boat should have been faster, no? I was just asking a simple question on why it didn't seem to work as well on the Fountain. Could be many reasons, sorry for wanting to be more knowledgeable about your product. No reason to be a d*ck about it!
Sunsation built an Ilmor F4 and despite 50 extra HP.......a Merc 700 boat was faster. They probably built 18 F4's, the other 17 were all Mercury powered (1 662, 1 1075, the rest 700 sci)
#67
725 Ilmor's & 700 Merc's are not exact but pretty equal. With the claims you make the Arenson boat should have been faster, no? I was just asking a simple question on why it didn't seem to work as well on the Fountain. Could be many reasons, sorry for wanting to be more knowledgeable about your product. No reason to be a d*ck about it!
#68
Registered
iTrader: (1)
Join Date: Sep 2005
Location: West Michigan
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
In all seriousness, it's not like I would have ever considered #6 drives on my boat for an alleged "couple mph faster" over Arnesons. I think we all know that 2mph (or even 10mph) can be the wrong trim, wrong props, wrong conditions/waves/current direction, incorrect setup (tie bar to far in/out, wrong x dimension, etc...), or any other host of reasons.
Besides the upfront cost of 6's being far higher, and maintenance on 6's is more frequent (and expensive) due to the use of bevel gears. 6's are also heavier (by hundreds of lbs)... which would be a huge issue on my boat.