Help...closed cooling setup..sbc alpha 1
01-28-2009, 07:43 PM
#1
Registered
Thread Starter
Join Date: Jan 2009
Location: Gladstone Queensland
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Help...closed cooling setup..sbc alpha 1
Hey Guys
I am currently setting up closed cooling system on sbc alpha 1.
The raw water tstat housing is still in place.
I am seeking advice and diagrams on the best way to setup as there is so many options.
The header tank is plumbed into the 1.25" raw water in position.
I am currently drawing and pushing coolant to h/exch via pump in and large tstat out and blocking the two tstat that should go to the exh mani.
I was thinking that this would provide full flow over exhausts.
Theres a hundred ways to hook this up but only one right way!!
Can anyone help please?
I am currently setting up closed cooling system on sbc alpha 1.
The raw water tstat housing is still in place.
I am seeking advice and diagrams on the best way to setup as there is so many options.
The header tank is plumbed into the 1.25" raw water in position.
I am currently drawing and pushing coolant to h/exch via pump in and large tstat out and blocking the two tstat that should go to the exh mani.
I was thinking that this would provide full flow over exhausts.
Theres a hundred ways to hook this up but only one right way!!
Can anyone help please?
Thread
Thread Starter
Forum
Replies
Last Post
Michael1
Drives and Lower Units
1
10-25-2007 05:35 AM
