ezstriper

finishing my inside Hyd steering install, cannot get the H/D hose supplied in the kit to go on the slip on filling on the cooler..only slip fit in the system...fitting made on cooler so can't change that..any idea's ? thanks Rob

Rookie

iTrader: (4)

That is the low pressure side right? I just used braided rubber hose from the local auto store. I think 3/8" rubber gas line.

ezstriper

Hate to have to change the whole hose..15' or more..goes all the way to the helm..plus would have to change the fitting there as well....

C_Spray

iTrader: (2)

Use an hosebarb-to-hosebarb adapter to go to the right size. Tuck it out of sight so it doesn't show, but you can still access it.

ezstriper

thanks, thats what I ended up doing..could not get the hose to slid on now matter what...found I have one hose end that did not seal !!!! but had to get winterized...cold coming !!