30' Activator Super V Light / Poker Run Edition
03-10-2016 | 09:00 AM
#491
Registered
Joined: Jul 2012
Posts: 373
Likes: 1
I am going to try a surface drive on this boat
03-10-2016 | 12:42 PM
#496
Registered
Joined: Mar 2002
Posts: 4,339
Likes: 1
From: Florida
A notch in the transom and also if it has a pad on it an example is fountain they run very well with a high X dimension actually did the same thing years ago in the F1 when they started the class there was no X dimention and then had to implement an X dimension rule when certain boats werel running much faster
Last edited by Xtremeracing; 03-10-2016 at 12:44 PM.
03-10-2016 | 01:05 PM
#497
Registered
Joined: Sep 2013
Posts: 171
Likes: 0
From: Fort Lauderdale, Florida
Imco is also an approved drive manufacture. The X dimension cant be higher than 1/2 " below the bottom. You can go down as far as you want. I remember seeing a canopied A class boat race years ago (aprox 1999) with a shaft drive on it. It was racing against the Extinguisher Super Boat which at the time was the boat to beat in A class. The smaller shaft boat was putting on a race in the big water at Point Pleasant in a much smaller boat. They may have won that day I don't remember. I believe I remember seeing it on the side of the road in the Key's when we drove down there.
03-10-2016 | 08:35 PM
#498
Registered
Joined: May 2009
Posts: 1,941
Likes: 526
surface drve like the arneson bravo conversion, or is patching and re-cutting the transom a non issue, also not knowing how long the engine room is for room with a trans.
what kind of engine mounts are you planning on using
what kind of engine mounts are you planning on using
03-10-2016 | 08:40 PM
#499
Registered
Joined: Jul 2012
Posts: 373
Likes: 1
Imco scx 4 . Its 4 inches shorter .Uses the imco hd gimble speed master props
