Removing side panels...
Climb up in the gunwhales and unbolt? Trying to figure out where to place these subs.


Are the bolsters screwed down or bolted down? If I pull out the screws into the floor; are the nuts going to fall off?



Did my dash switch ship out? THANKS!

TTT Pat?

Bryan,

Yeah, you have to reach up there for the lock-nuts on the combing panel. A real pain in the butt. There are aluminum plates under the bolsters. Unscrewing them should be no problem. Of course picking those heavy suckers up might make your nuts fall off....

And I have 2 switches on my desk and your address. I am going to the post office Monday.

So what is it exactly that you are attempting to do with this dissection of the cockpit?

Pat

Thanks Pat, Check your PM.