|
Re: 41 Apache in Grand Haven MI
I just measured my #3 propshaft diameter. It is 1.25 with 19 splines. The measurement taken is the outside diameter of the propshaft at the splines right after the threads.
|
Re: 41 Apache in Grand Haven MI
Thanks Cig,
Now how many on a 3a? 19 vs ??? |
Re: 41 Apache in Grand Haven MI
Originally Posted by bryanspeedracer
Thanks Cig,
Now how many on a 3a? 19 vs ??? |
Re: 41 Apache in Grand Haven MI
Thanks guys
|
Re: 41 Apache in Grand Haven MI
I think I called about this boat when it was in NJ last summer. Once motor was seized and the other hadn't been started for a while. Not sure if it is the same boat but I spoke to DanL's brother.
|
Re: 41 Apache in Grand Haven MI
As far as the fuel tanks go, only the bow tank needs to be looked at on the pleasure version. On the 3a's, I wouldn't put more than 800 hp on them on a boat that heavy, it's just too much load for the drive to handle. You can put bigger power in the boat and go faster, but why risk the durability and longevity of the drivetrain, someone is ALWAYS going to be faster.
Robert |
Re: 41 Apache in Grand Haven MI
a 41 apache runs good 850hp an #6 drives.
|
Re: 41 Apache in Grand Haven MI
This boat was owned by a board member who now owns a 28 saber. Post this question in the general forum and he may see it. NK
|
Re: 41 Apache in Grand Haven MI
used to be owned by Jay Vanderwoude. contact him at east belting towing in grand rapids michigan
|
Re: 41 Apache in Grand Haven MI
east beltline towing 616-942-5210 - do they still have the old wave hippie boat?
|
| All times are GMT -5. The time now is 05:42 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.