I just measured my #3 propshaft diameter. It is 1.25 with 19 splines. The measurement taken is the outside diameter of the propshaft at the splines right after the threads.

Thanks Cig,

Now how many on a 3a?

19 vs ???

26 splines on a 3A SSM

Thanks guys

I think I called about this boat when it was in NJ last summer. Once motor was seized and the other hadn't been started for a while. Not sure if it is the same boat but I spoke to DanL's brother.

As far as the fuel tanks go, only the bow tank needs to be looked at on the pleasure version. On the 3a's, I wouldn't put more than 800 hp on them on a boat that heavy, it's just too much load for the drive to handle. You can put bigger power in the boat and go faster, but why risk the durability and longevity of the drivetrain, someone is ALWAYS going to be faster.

Robert

a 41 apache runs good 850hp an #6 drives.

This boat was owned by a board member who now owns a 28 saber. Post this question in the general forum and he may see it. NK

used to be owned by Jay Vanderwoude. contact him at east belting towing in grand rapids michigan

east beltline towing 616-942-5210 - do they still have the old wave hippie boat?