New Motors
#13
Registered
Well they are coming along very nice.
I was down at Mark's shop yesterday morning to drop off some accessories and pick up the 500's and bring them back home and I took the following pictures of the long blocks and the Whipples.
They should be complete and ready for the dyno in about three weeks if all goes well.
I was down at Mark's shop yesterday morning to drop off some accessories and pick up the 500's and bring them back home and I took the following pictures of the long blocks and the Whipples.
They should be complete and ready for the dyno in about three weeks if all goes well.
#14
Registered
Join Date: Dec 2006
Location: ATL, GA
Posts: 492
Likes: 0
Received 0 Likes
on
0 Posts
We like running up to the Ale House and hanging out there as well as heading over to the Rudder. Also, like Cock Tail Cove (I think that is what it's called) where you are right against the Pointe Golf Coarse.
#15
Charter Member #34
Charter Member
Thread Starter
Join Date: Oct 2000
Location: Beautiful North Carolina
Posts: 7,151
Likes: 0
Received 1 Like
on
1 Post
They will build up internal heat in the air charge which is why you need a GOOD intercooler and I selected the Stage II. Not any excessive ambient heat.
YES
I cannot wait either!
Thanks DAWG you to.
YES
I cannot wait either!
Thanks DAWG you to.
#17
Charter Member #34
Charter Member
Thread Starter
Join Date: Oct 2000
Location: Beautiful North Carolina
Posts: 7,151
Likes: 0
Received 1 Like
on
1 Post
That is Elliott Sadlers house on the left as you enter with the 38 Fountain on the lift.
We'll e looking for you come May if all goes well.
#18
Charter Member #34
Charter Member
Thread Starter
Join Date: Oct 2000
Location: Beautiful North Carolina
Posts: 7,151
Likes: 0
Received 1 Like
on
1 Post
Only 1” is needed in front of your engine and the SC is the same height as your factory stainless headers (Stages 3 require 1”), a perfect fit for almost all applications.