I just sold my 25 Outlaw (Mag 502 ran 67) and bought a 29 Fountain (525hp runs 80). I had wanted to put a blower in the 25 Outlaw but decided to sell it after the research.

I have a buddy with and 25 Outlaw. His Outlaw has an 830 Hp Blower shop motor in it. He gets 86 out of it. The prob as I understand it with the Baja is the X Axis is to low and the pad is notched. Another way to put it, the motor would make a velocity, Kryptonite etc. run much faster. You reach a wall when it comes to speed with that hull. ALthough, the hull turns spectacular and handles the rough stuff very well.

The other prob I had, (he did too) is the the stringers started to twist from motor torque. In the end, I opted for a different boat with more potential.

Ah! The Famous Baja Stringer problems

Something nice and cheap!

Ok I'll check them out, Considering most of these people don't even get back with you, when you inquire about their boats.

where is the link ? www???

CAPO71, did you get my reply e-mails? I hope your not talking about me. If so, my e-mail is screwed up.

CFD5 I never got any e-mails from you ? Where did you send them ? To me directly? or through OsO Private messaging?

I replied directly to your e-mail. Sorry you did not get them, I sent two e-mails right after you e-mailed me. I will check my e-mail to make sure I sent them to the right address. Sorry for the confusion, I was not trying to avoid you.

It's ok I'm at [email protected]



It's a zero in my address I always get people telling me they mailed it to the letter O

Just checked my e-mail, sent them to your AOL account. I can re send them through pm if you like. Your AOL account might have kicked me into your junk mail. Let me know what I can do. Again, sorry.