Just picked up a Bravo Drive and was wondering about X Dimensions. I know the Panteras are 6 inches narrower, but looks like they run between 17 and 17.5. Anyone have any suggestions.

Ok I know someone out here knows about x dimension. Currently the propshaft is 6 inches below the keel this seems low to me. I'm going with a bravo and small block and am trying to figure out what height to go with?

run 17.5 on just about everything i build, seems to be a good performance X dim without being to high.

Thanks Glass Dave. That's the number I was thinking about.

This was an older post on this site that offered some advise.....http://www.offshoreonly.com/forums/g...boat-hull.html

Does anyone know the difference in length (input shaft to output shaft) between TRS and Bravo?

jeff

trs 24 3/16
b1 21 13/16

Thank you.

Jeff